Component Inspection

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.

Turn ignition switch OFF. (Stay for at least 5 seconds.)
Disconnect transfer terminal cord assembly harness connector.

Check resistance between transfer terminal cord assembly terminals 2 and 3.

Temperature °C (°F)	Resistance (Approx.)
20 (68)	2.5 kΩ
80 (176)	0.3 kΩ

If the inspection results are abnormal replace the transfer fluid temperature sensor. Refer to "COMPONENT PARTS LOCATION ".

Fig 1: Checking Resistance Between Transfer Terminal Cord Assembly Terminals 2 And 3
Courtesy of NISSAN NORTH AMERICA, INC.