Transfer Motor Relay

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.

Turn ignition switch OFF. (Stay for at least 5 seconds.)
Remove transfer motor relay. Refer to "COMPONENT PARTS LOCATION ".
Apply 12V direct current between transfer motor relay terminals 1 and 2.

Check continuity between relay terminals 3 and 5.

Condition	Continuity
12V direct current supply between terminals 1 and 2	Yes
OFF	No

Fig 1: Applying 12V Direct Current Between Transfer Motor Relay Terminals 1 And 2

Courtesy of NISSAN NORTH AMERICA, INC.

If inspection results are abnormal replace transfer motor relay.