LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2004 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 910 (Transfer Case) >> DTC/Circuit Diagnosis >> DTC P1823: 2-4 Solenoid >> Component Inspection

Component Inspection

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition switch OFF. (Stay for at least 5 seconds.)
  2. Disconnect transfer terminal cord assembly harness connector.
  3. Check resistance between transfer terminal cord assembly terminals 4 and 5.

    4 - 5: Approx. 22.8 - 25.2 Ω 

  4. If the inspection results are abnormal replace the 2-4WD solenoid. Refer to "COMPONENT PARTS LOCATION ".
    Fig 1: Checking Resistance Between Transfer Terminal Cord Assembly Terminals 4 And 5
    G04901531Courtesy of NISSAN NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals