LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2004 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 910 (Transfer Case) >> DTC/Circuit Diagnosis >> DTC P1822: Clutch Pressure Solenoid >> Component Inspection >> Transfer Dropping Resistor

Transfer Dropping Resistor

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition switch OFF. (Stay for at least 5 seconds.)
  2. Disconnect transfer dropping resistor harness connector.
  3. Check resistance between transfer dropping resistor terminals 1 and 2.

    1 - 2: Approx. 11.2 - 12.8 Ω 

  4. If the inspection results are abnormal replace transfer dropping resistor. Refer to "COMPONENT PARTS LOCATION ".
    Fig 1: Checking Resistance Between Transfer Dropping Resistor Terminals 1 And 2
    G04901523Courtesy of NISSAN NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals