Component Inspection

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.

Remove transfer control device. Refer to "REMOVAL AND INSTALLATION ".

Check operation by applying battery voltage to transfer control device (actuator motor) terminals 21 and 24.

CAUTION:

Do not operate actuator motor for more than 1 second.
Change the actuator motor position to HIGH when installing.
Be careful not to overheat the harness.

Terminal	Continuity	Continuity
24 (Battery voltage) - 21 (Ground)	20 - 22	Yes
24 (Battery voltage) - 21 (Ground)	22 - 23	No
21 (Battery voltage) - 24 (Ground)	22 - 23	Yes
21 (Battery voltage) - 24 (Ground)	20 - 22	No

Fig 1: Applying Battery Voltage To Transfer Control Device (Actuator Motor) Terminals 21 And 24

Courtesy of NISSAN NORTH AMERICA, INC.

If the inspection results are abnormal replace transfer control device (actuator motor).