LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2004 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 909 (Propeller Shaft (2S1410)) >> Unit Disassembly And Assembly >> Propeller Shaft >> Disassembly and Assembly >> Disassembly >> Journal

Disassembly and Assembly: Disassembly: Journal

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
  1. Put matching marks on the rear propeller shaft and flange yoke as shown below.
    CAUTION: For matching marks use paint. Do not damage the rear propeller shaft or flange yoke.
    Fig 1: Identifying Matching Marks On Rear Propeller Shaft And Flange Yoke
    G04901785Courtesy of NISSAN NORTH AMERICA, INC.
  2. Remove the snap rings.
    Fig 2: Removing Snap Rings
    G06580292Courtesy of NISSAN NORTH AMERICA, INC.
  3. Push out and remove the journal bearings by lightly tapping the flange yoke with a hammer, taking care not to damage the journal or flange yoke hole.
    NOTE: Put marks on the disassembled parts so that they can be reinstalled in their original positions from which they were removed.
    Fig 3: Removing Journal Bearings Using Hammer
    G04901787Courtesy of NISSAN NORTH AMERICA, INC.
  4. Push out and remove the remaining journal bearings at the opposite side by lightly tapping the flange yoke with a hammer, taking care not to damage the journal or flange yoke hole.
    NOTE: Put marks on the disassembled parts so that they can be reinstalled in their original positions from which they were removed.
    Fig 4: Tapping Flange Yoke
    G04901788Courtesy of NISSAN NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals