LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2004 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 908 (Front Propeller Shaft (2F1310)) >> Unit Removal And Installation >> Propeller Shaft >> Removal and Installation >> Model 2F1310 >> Removal

Model 2F1310: Removal

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the under cover (if equipped).
  2. Put matching marks on the front propeller shaft flange yoke and the front final drive companion flange as shown below.
    CAUTION: For matching marks, use paint. Do not damage the flange yoke and companion flange of the front final drive.
  3. Put matching marks on the front propeller shaft flange yoke and the transfer companion flange.
    CAUTION: For matching marks, use paint. Do not damage the flange yoke and companion flange of the front final drive.
  4. Remove the bolts and then remove the front propeller shaft from the front final drive and transfer.
    Fig 1: Identifying Matching Marks On Front Propeller Shaft Flange Yoke And Transfer Companion Flange
    G04901782Courtesy of NISSAN NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals