Disassembly and Assembly: Disassembly: Journal

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.

Put matching marks on the front propeller shaft and flange yoke as shown below.
CAUTION: For matching marks, use paint. Do not damage the front propeller shaft or flange yoke.

Fig 1: Identifying Matching Marks On Front Propeller Shaft And Flange Yoke
Courtesy of NISSAN NORTH AMERICA, INC.
Remove the snap rings.

Fig 2: Removing Driveshaft Snap Rings
Courtesy of NISSAN NORTH AMERICA, INC.
Push out and remove the journal bearings by lightly tapping the flange yoke with a hammer, taking care not to damage the journal or flange yoke hole.
NOTE: Put marks on the disassembled parts so that they can be reinstalled in their original positions from which they were removed.

Fig 3: Removing Journal Bearing Using Hammer
Courtesy of NISSAN NORTH AMERICA, INC.
Push out and remove the remaining journal bearings at the opposite side by lightly tapping the flange yoke with a hammer, taking care not to damage the journal or flange yoke hole.
NOTE: Put marks on the disassembled parts so that they can be reinstalled in their original positions from which they were removed.

Fig 4: Removing Flange Yoke Journal Bearings Using Hammer
Courtesy of NISSAN NORTH AMERICA, INC.