LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2004 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 905 (Seat Belts) >> Removal And Installation >> Seat Belts >> Removal and Installation of Front Seat Belt >> Front Seat Belt Buckle >> Removal

Front Seat Belt Buckle: Removal

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front seat. Refer to "REMOVAL AND INSTALLATION - FRONT SEAT ASSEMBLY ".
  2. Remove the seat cushion. Refer to "DISASSEMBLY AND ASSEMBLY ".
  3. Disconnect the harness connector from seat belt buckle pre-tensioner.
    CAUTION:
    • For removing pre-tensioner harness connector, insert a thin screwdriver (1) wrapped in tape (3) into the notch. Lift the locking tab to unlock (2), then remove the connector.
    • Install the pre-tensioner harness connector with the locking tab raised, then push the locking tab into the connector to lock (4).
  4. Remove screw and seat cushion inner finisher.
    Fig 1: Removing Pre-Tensioner Harness Connector Using Thin Screwdriver
    G04902339Courtesy of NISSAN NORTH AMERICA, INC.
  5. Remove the seat belt buckle anchor bolt and the seat belt buckle.
    Fig 2: Seat Belt Buckle Mounting Bolt With Torque Specification
    G06581258Courtesy of NISSAN NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals