LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2004 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 905 (Seat Belts) >> Basic Inspection >> Component Inspection >> Inspection >> Seat Belt Retractor On-Vehicle Check >> ALR Function Stationary Check

ALR Function Stationary Check

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
  1. Pull out the entire length of seat belt from retractor until a click is heard.
  2. Retract the webbing partially. A clicking noise should be heard as the webbing retracts, indicating that the retractor is in the Automatic Locking Retractors (ALR) mode.
  3. Grasp the seat belt and try to pull out the retractor. The webbing must lock and not extend any further. If it does not operate normally, replace the retractor assembly.
  4. Allow the entire length of the webbing to retract to cancel the automatic locking mode.
scientia non olet · About LEMON Manuals