LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2004 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 905 (Seat Belts) >> Basic Inspection >> Collision Diagnosis >> For Side and Rollover Collision >> FOR SIDE AND ROLLOVER COLLISION: When SRS is activated in a collision >> Work Procedure

Work Procedure

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
  1. Before performing any of the following steps, ensure that all vehicle body and structural repairs have been completed.
  2. Replace the following components:
    • Front seat back assembly (on the side on which side air bag is activated).
    • Door finisher (on the side on which door-mounted curtain air bag is activated).
    • Pop-up roll bar assemblies and pop-up roll bar covers.
    • Side air bag (satellite) sensor LH/RH (on the side on which side air bag is activated).
    • Diagnosis sensor unit.
    • Seat belt pre-tensioner assemblies.
  3. Check the SRS components and the related parts using the following table.

    Replace any SRS components and the related parts showing visible signs of damage (dents, cracks, deformation, etc.).

  4. Perform self-diagnosis using CONSULT and "AIR BAG" warning lamp. Refer to "SRS OPERATION CHECK " for details. Make sure entire SRS operates properly.
  5. After the work is completed, perform self-diagnosis to check that no malfunction is detected. Refer to "TROUBLE DIAGNOSIS WITHOUT CONSULT ".
scientia non olet · About LEMON Manuals