LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2004 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 904 (Seats) >> Unit Disassembly And Assembly >> Front Seat >> Disassembly and Assembly >> Seatback Trim And Pad >> Disassembly

Seatback Trim And Pad: Disassembly

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Only complete seatback assemblies can be replaced on vehicles equipped with side air bags.
  • When removing or installing the seat trim, handle it carefully to keep dirt out and avoid damage.
  1. Remove the seatback assembly. Refer to "REMOVAL AND INSTALLATION - FRONT SEAT ASSEMBLY ".
  2. Remove the headrest.
  3. From inside of the seatback, squeeze the headrest holder tabs at the base of the stay pipe and pull the up to remove.
    NOTE: Before installing the headrest holder, check its orientation (front/rear and right/left).
    Fig 1: Identifying Headrest Holder And Tab
    G04903088Courtesy of NISSAN NORTH AMERICA, INC.
  4. Remove the snap ring and the lumbar support lever knob (if equipped).
    Fig 2: Identifying Snap Ring And Lumbar Support Lever Knob
    G04903089Courtesy of NISSAN NORTH AMERICA, INC.
  5. Remove the seatback trim and pad assembly.
  6. Remove the hog rings to separate the seatback trim from the pad.
scientia non olet · About LEMON Manuals