LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2004 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 904 (Seats) >> Removal And Installation >> Third Seat >> Removal and Installation - RH Seat >> Removal

Removal and Installation - RH Seat: Removal

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the storage bin. Refer to LUGGAGE FLOOR TRIM .
  2. Remove the seat nut finisher.
  3. Remove the two front nuts (A) and the front RH seatback frame assembly bolt (B).
    Fig 1: Identifying Front RH Seatback Frame Assembly Bolt And Front Nuts
    G04903103Courtesy of NISSAN NORTH AMERICA, INC.
  4. Remove the seat cushion side facing retainer clip and release elastic band from seat belt buckle.
  5. Partially lift seatback upright, then remove seat belt buckle (2) from between the hinge finisher (LH) (1) and the seat cushion trim (3).
    Fig 2: Removing Seat Belt Buckle From Between Hinge Finisher (LH) And Seat Cushion Trim
    G08694275Courtesy of NISSAN NORTH AMERICA, INC.
  6. Move the seat to the folded flat position.
  7. Remove the rear bolts and the seat assembly.
    Fig 3: Locating Rear Bolts Of Seat Assembly
    G04903106Courtesy of NISSAN NORTH AMERICA, INC.


  1. Remove the storage bin. Refer to LUGGAGE FLOOR TRIM .
  2. Remove the seat nut finisher.
  3. Remove front seat nuts (A) and front RH seatback assembly bolt (B).
    Fig 1: Identifying Front RH Seatback Frame Assembly Bolt And Front Nuts
    G04903103Courtesy of NISSAN NORTH AMERICA, INC.
  4. Remove the seat cushion side facing retainer clip and release elastic band from seat belt buckle.
  5. Partially lift seatback upright, then remove seat belt buckle (2) from between the hinge finisher (LH) (1) and the seat cushion trim (3).
    Fig 2: Removing Seat Belt Buckle From Between Hinge Finisher (LH) And Seat Cushion Trim
    G08694311Courtesy of NISSAN NORTH AMERICA, INC.
  6. Move the seat to the folded flat position.
  7. Remove the rear bolts from the seat assembly.
    Fig 3: Locating Rear Bolts Of Seat Assembly
    G04903106Courtesy of NISSAN NORTH AMERICA, INC.
  8. Disconnect the seat harness.
  9. Remove the seat assembly.
scientia non olet · About LEMON Manuals