LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2004 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 904 (Seats) >> Removal And Installation >> Third Seat >> Removal and Installation - LH Seat >> Removal

Removal and Installation - LH Seat: Removal

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the storage bin. Refer to LUGGAGE FLOOR TRIM .
  2. Remove the seat nut finishers.
  3. Remove the two front nuts and the front LH seatback frame assembly bolt.
    Fig 1: Identifying Seatback Frame Assembly Bolt And Mounting Nuts
    G04903098Courtesy of NISSAN NORTH AMERICA, INC.
  4. Remove the seat cushion side facing retainer clip and release elastic band from seat belt buckle.
  5. Partially lift seatback upright, then remove seat belt buckle (2) from between the hinge finisher (RH) (1) and the seat cushion trim (3).
    Fig 2: Removing Seat Belt Buckle From Between Hinge Finisher (RH) And Seat Cushion Trim
    G08694272Courtesy of NISSAN NORTH AMERICA, INC.
  6. Move the seat to the folded flat position.
  7. Remove the rear seat bolt (A) and the seat belt buckle bolt (B).
    CAUTION: Do not reuse the seat belt buckle bolt.
    Fig 3: Identifying Rear Seat Bolt And Seat Belt Buckle Bolt
    G04903101Courtesy of NISSAN NORTH AMERICA, INC.
  8. Remove the seat assembly.


  1. Remove the storage bin. Refer to LUGGAGE FLOOR TRIM .
  2. Remove the seat nut finishers.
  3. Remove the two front nuts and the front LH seatback frame assembly bolt.
    Fig 1: Identifying Seatback Frame Assembly Bolt And Mounting Nuts
    G04903098Courtesy of NISSAN NORTH AMERICA, INC.
  4. Remove the seat cushion side facing retainer clip and release elastic band from seat belt buckle.
  5. Partially lift seatback upright, then remove seat belt buckle (2) from between the hinge finisher (RH) (1) and seat cushion trim (3).
    Fig 2: Removing Seat Belt Buckle From Between Hinge Finisher (RH) And Seat Cushion Trim
    G08694280Courtesy of NISSAN NORTH AMERICA, INC.
  6. Move the seat to the folded flat position.
  7. Remove the rear seat bolt (A) and seat belt buckle bolt (B).
    CAUTION: Do not reuse the seat belt buckle bolt.
    Fig 3: Identifying Rear Seat Bolt And Seat Belt Buckle Bolt
    G04903101Courtesy of NISSAN NORTH AMERICA, INC.
  8. Disconnect the seat harness.
  9. Remove the seat assembly.
scientia non olet · About LEMON Manuals