Removal and Installation - Front Seat Assembly: Removal

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Do not leave any objects (screwdrivers, tools, etc.) on the seat during seat repair. It can lead to personal injury if the side air bag module should accidentally deploy.

CAUTION:

When removing or installing the seat trim, handle it carefully to keep dirt out and avoid damage.
Before removing the front seat, turn the ignition switch off, disconnect both battery cables and wait at least three minutes.
When checking the power seat circuit for continuity using a circuit tester, do not confuse its connector with the side air bag module connector. Such an error may cause the air bag to deploy.
Do not drop, tilt, or bump the side air bag module while installing the seat. Always handle it with care.
After front side air bag module inflates, front seatback assembly must be replaced.
Front passenger seat is equipped with an Occupant Classification System sensor and control module. Do not disassemble front passenger seat cushion assembly or remove the trim as this will affect the Occupant Classification System calibration.
Always replace passenger seat cushion as an assembly.
When removing and installing the seat, use shop cloths to protect the vehicle from damage.

Position the seat until the four seat bolts are accessible. Remove the bolt covers and the bolts.
NOTE: If disassembling the seat after removal, set the front/rear cushion lifters to the top position.
Disconnect the negative and positive battery terminals and wait at least three minutes. Refer to "REMOVAL AND INSTALLATION ".
Remove the four seat bolts.
Tilt the seat to disconnect the harness connectors from the seat and remove.