LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2004 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 902 (Exterior Lighting System) >> Symptom Diagnosis >> Exterior Lighting System Symptoms >> Symptom Table

Symptom Table

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Perform the self-diagnosis with CONSULT before the symptom diagnosis. Perform the trouble diagnosis if any DTC is detected.
Symptom Possible cause Inspection item
Headlamp does not switch to the high beam. One side
  • Fuse
  • Harness between IPDM E/R and the front combination lamp
  • Front combination lamp (High beam relay)
  • IPDM E/R
Headlamp (HI) circuit
Refer to HEADLAMP (HI) CIRCUIT .
Both sides Symptom diagnosis 
"BOTH SIDE HEADLAMPS DO NOT SWITCH TO HIGH BEAM" Refer to BOTH SIDE HEADLAMPS DO NOT SWITCH TO HIGH BEAM .
High beam indicator lamp is not turned ON.
(Headlamp switches to the high beam.)
  • Combination meter
  • BCM
  • Combination meter.

    Data monitor "HI-BEAM IND"

  • BCM (HEAD LAMP) Active test "HEADLAMP"
Headlamp does not switch to the low beam. One side Front combination lamp (Low beam relay) -
Both sides
  • Combination switch (lighting and turn signal switch)
  • Harness between the combination switch (lighting and turn signal switch) and BCM
  • BCM
Combination switch (lighting and turn signal switch) Refer to SYMPTOM DIAGNOSIS .
High beam request signal
  • BCM
  • IPDM E/R
IPDM E/R
Data monitor "HL HI REQ"
IPDM E/R -
Headlamp does not turn ON. One side
  • Fuse
  • Bulb
  • Harness between IPDM E/R and the front combination lamp
  • Front combination lamp
  • IPDM E/R
Headlamp (LO) circuit Refer to HEADLAMP (LO) CIRCUIT .
Both sides Symptom diagnosis 
"BOTH SIDE HEADLAMPS (LO) ARE NOT TURNED ON"
Refer to "DESCRIPTION ".
Headlamp does not turn OFF. When the ignition switch is turned ON
  • BCM
  • Combination switch (lighting and turn signal switch)
Combination switch (lighting and turn signal switch) Refer to SYMPTOM DIAGNOSIS .
Headlamp is not turned ON/OFF with the lighting switch AUTO.
  • Combination switch (lighting and turn signal switch)
  • Harness between the combination switch (lighting and turn signal switch) and BCM
  • BCM
Combination switch (lighting and turn signal switch) Refer to SYMPTOM DIAGNOSIS .
  • Optical sensor
  • Harness between the optical sensor and BCM
  • BCM
Optical sensor Refer to OPTICAL SENSOR .
Daytime light system does not activate.
  • Either high beam bulb
  • Parking brake switch
  • Combination switch (lighting and turn signal switch)
  • BCM
  • IPDM E/R
  • Daytime light relay
  • Harness between IPDM E/R and daytime light relay.
Daytime light system description.
Refer to "SYSTEM DESCRIPTION ".
Front fog lamp is not turned ON. One side
  • Front fog lamp bulb
  • Harness between IPDM E/R and the front combination lamp
  • Front combination lamp
  • IPDM E/R
Front fog lamp circuit
Refer to FRONT FOG LAMP CIRCUIT .
Both side Symptom diagnosis 
"BOTH SIDE FRONT FOG LAMPS ARE NOT TURNED ON" Refer to BOTH SIDE FRONT FOG LAMPS ARE NOT TURNED ON .
Parking lamp is not turned ON. One side
  • Fuse
  • Parking lamp bulb
  • Harness between IPDM E/R and the front/rear combination lamp
  • Front/rear combination lamp
  • IPDM E/R
Parking lamp circuit Refer to PARKING LAMP CIRCUIT .
Both sides Symptom diagnosis 
"PARKING, LICENSE PLATE AND TAIL LAMPS ARE NOT TURNED ON" Refer to PARKING, LICENSE PLATE AND TAIL LAMPS ARE NOT TURNED ON .
Turn signal lamp does not blink. Indicator lamp is normal. (The applicable side performs the high flasher activation).
  • Harness between BCM and each turn signal lamp
  • Turn signal lamp bulb
  • Door mirror (if equipped with turn signals in the door mirrors)
Turn signal lamp circuit Refer to TURN SIGNAL LAMP CIRCUIT .
Turn signal indicator lamp does not blink. One side Combination meter -
Both sides (Always)
  • Turn signal indicator lamp signal
  • Combination meter
  • BCM
  • Combination meter. Data monitor "TURN IND"
  • BCM (FLASHER) Active test "FLASHER"
Both sides (Does blink when activating the hazard warning lamp with the ignition switch OFF)
  • The combination meter power supply and the ground circuit
  • Combination meter
Combination meter
Power supply and the ground circuit Refer to POWER SUPPLY AND GROUND CIRCUIT .