LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2004 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 900 (Brake System) >> Unit Disassembly And Assembly >> Rear Disc Brake >> Disassembly and Assembly >> Disassembly

Disassembly and Assembly: Disassembly

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove pads from cylinder body.
  2. Remove sliding sleeve and boot from cylinder body.
  3. Place a wooden block as shown below, and blow air into union bolt hole to remove piston and piston boot.
    WARNING: Do not get your fingers caught in piston.
    Fig 1: Removing Piston And Piston Boot Using Blow Air
    G04876709Courtesy of NISSAN NORTH AMERICA, INC.
  4. Using a suitable tool, remove piston seal from cylinder body as shown below.
    CAUTION: Be careful not to damage cylinder body inner wall.
  5. Remove the bleed valve and cap.
    Fig 2: Removing Piston Seal From Cylinder Body Using Tool
    G04902227Courtesy of NISSAN NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals