LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2004 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 900 (Brake System) >> Unit Disassembly And Assembly >> Brake Master Cylinder >> Disassembly and Assembly >> Disassembly

Disassembly and Assembly: Disassembly

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Master cylinder assembly cannot be disassembled.
  • Do not drop parts. If a part is dropped, do not use it.
  1. Pull the reservoir tank off the master cylinder assembly.
  2. Remove the grommets from master cylinder assembly and discard the grommets.
    CAUTION: Discard the grommets, do not reuse.
  3. Remove the fluid level sensor from the reservoir tank.
  4. Remove the front and rear pressure sensors and discard.
    CAUTION: Discard the front and rear pressure sensors, do not reuse.
scientia non olet · About LEMON Manuals