Removal and Installation of Brake Pad: Installation

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.

Push piston in using suitable tool.
CAUTION: By pushing in piston, brake fluid returns to master cylinder reservoir tank. Watch the brake fluid level in the reservoir tank.
Apply Molykote 7439 grease to brake pad contact areas on knuckle.
CAUTION: Do not get grease on the brake pads or brake rotor friction surfaces.
Install pads to cylinder body.
Install cylinder body to torque member.
Install sliding pin bolts and tighten to specified torque. Refer to "EXPLODED VIEW OF BRAKE CALIPER ".
Check rear disc brake for drag.
Install rear wheel and tire. Refer to "ROTATION ".
Check brake fluid level. Refer to "ON BOARD INSPECTION ".