Removal and Installation of Brake Caliper and Disc Rotor: Installation
WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
- If reusing the disc rotor, use the matching marks to align disc rotor on the wheel hub assembly, then install disc rotor using a wheel nut to hold it in place.CAUTION: Use matching marks on wheel hub assembly and disc rotor if the disc rotor is to be reused.
- Install cylinder body and tighten cylinder body bolts to specification.CAUTION: Before installing cylinder body to the vehicle, wipe off mating surface of cylinder body.
- Install brake hose to cylinder body with new copper sealing washers (1) and tighten union bolt (A) to specification.CAUTION:
- Do not reuse copper sealing washers.
- Securely attach brake hose to projection on cylinder body.
- Refill with new brake fluid and bleed. Refer to "BLEEDING BRAKE SYSTEM ".
- Check rear disc brake for drag and correct as necessary.
- Install rear wheels and tires. Refer to "ROTATION ".