Removal and Installation: Removal
WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- Before removal and installation, the accelerator and brake pedals must be in the forward most position (closest to the floor). This is to align the base position of the accelerator and brake pedals.
- Do not disassemble the brake pedal adjusting mechanism.
- Avoid damage from dropping the brake pedal assembly during handling.
- Keep the brake pedal assembly away from water.
- Remove the instrument lower panel LH. Refer to "EXPLODED VIEW ".
- Disconnect and remove the stop lamp switch and ASCD cancel switch from the pedal assembly.
- Disconnect the adjustable brake pedal cable from the adjustable pedal electric motor.
- Unlock (1) then pull (2) the adjustable brake pedal cable to disconnect it from the adjustable pedal electric motor as shown below.
- Remove snap pin and clevis pin from the clevis of brake booster.
- Remove brake pedal assembly nuts and remove the brake pedal assembly.
- Temporarily install the brake pedal assembly nuts by hand to support the brake booster.
WARNING: Do not bend the brake tubing.CAUTION:- Before removal and installation, the accelerator and brake pedals must be in the forward most position (closest to the floor). This is to align the base position of the accelerator and brake pedals.
- Do not disassemble the brake pedal adjusting mechanism.
- Avoid damage from dropping the brake pedal assembly during handling.
- Keep the brake pedal assembly away from water.