LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2004 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 900 (Brake System) >> Removal And Installation >> Brake Booster >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove air duct and resonator assembly. Refer to "REMOVAL AND INSTALLATION ".
  2. Remove cowl top extension. Refer to "REMOVAL AND INSTALLATION ".
  3. Remove master cylinder assembly from brake booster. Refer to "REMOVAL AND INSTALLATION ".
  4. Remove vacuum hose from brake booster. Refer to "REMOVAL AND INSTALLATION ".
  5. Disconnect active booster and delta stroke sensor harness connectors from brake booster.
  6. Remove the instrument lower panel LH. Refer to "EXPLODED VIEW ".
  7. Remove brake pedal to clevis attachment snap pin and clevis pin from inside the vehicle.
  8. Remove brake booster to brake pedal assembly nuts.
  9. Reposition the A/C line out of the way.
  10. Remove brake booster and spacer block from dash panel.
scientia non olet · About LEMON Manuals