LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2004 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 900 (Brake System) >> Removal And Installation >> Brake Booster >> Removal and Installation >> Inspection After Removal >> Output Rod Length Inspection

Output Rod Length Inspection

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using a hand vacuum pump, apply a vacuum of - 66.7 kPa (- 500 mm Hg, -19.69 in Hg) to brake booster.
  2. Check output rod length.

    Output rod length: Refer to  "BRAKE BOOSTER ".

    Fig 1: Applying Vacuum To Brake Booster Using Hand Vacuum Pump
    G04876658Courtesy of NISSAN NORTH AMERICA, INC.