Removal and Installation: Removal
WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
- Remove wheel sensor bolt.
- When removing the front wheel sensor, first remove the disc rotor to gain access to the front wheel sensor bolt. Refer to "REMOVAL AND INSTALLATION OF BRAKE CALIPER AND DISC ROTOR ".
- When removing the rear wheel sensor, first remove the rear hub and bearing assembly to gain access to the rear wheel sensor bolt. Refer to "UNIT REMOVAL AND INSTALLATION ".
- Pull out the sensor, being careful to turn it as little as possible.CAUTION:
- Do not pull on the sensor harness.
- Disconnect wheel sensor harness electrical connector, then remove harness from attaching points.