Removal and Installation: Installation
WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
Installation is in the reverse order of removal. Tighten wheel sensor bolt to specification.
CAUTION:
- Inspect wheel sensor O-ring, replace sensor assembly if damaged.
- Before installing wheel sensor, make sure no foreign materials (such as iron fragments) are adhered to the pick-up part of the sensor, to the inside of the sensor hole or on the rotor mating surface.
- Apply a coat of suitable grease to the wheel sensor O-ring and hole. Refer to "RECOMMENDED CHEMICAL PRODUCTS AND SEALANTS ".