Removal and Installation: Removal
WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
When removing components such as hoses, tubes/lines, etc., cap or plug openings to prevent fluid from spilling.
- Disconnect the battery negative terminal. Refer to "REMOVAL AND INSTALLATION ".
- Remove the air cleaner and air duct resonator assembly. Refer to "REMOVAL AND INSTALLATION ".
- Disconnect the actuator harness connector from the ABS actuator and electric unit (control unit).
- Disconnect the brake tubes.CAUTION:
- To remove the brake tubes, use a flare nut wrench to prevent the flare nuts and brake tubes from being damaged.
- Be careful not to splash brake fluid on painted areas; it may cause paint damage. If brake fluid is splashed on painted areas, wash it away with water immediately.
- Remove the three bolts and remove the ABS actuator and electric unit (control unit).