Removal and Installation: Installation

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.

Installation is in the reverse order of removal.

CAUTION:

To install, use a flare nut crowfoot and torque wrench (commercial service tools).
Always tighten brake tubes to specification when installing.
Never reuse drained brake fluid.
After installation of the ABS actuator and electric unit (control unit), perform the following.
- Refill brake system with new brake fluid. Then bleed the air from the system. Refer to "BLEEDING BRAKE SYSTEM ".
- Adjust the steering angle sensor. Refer to "ADJUSTMENT OF STEERING ANGLE SENSOR NEUTRAL POSITION: SPECIAL REPAIR REQUIREMENT ".
- Calibrate the yaw rate/side/decel G sensor. Refer to "CALIBRATION OF DECEL G SENSOR: SPECIAL REPAIR REQUIREMENT ".