Data Monitor
WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
| Item (Unit) |
Data monitor item selection | Remarks | ||
|---|---|---|---|---|
| ECU INPUT SIGNALS | MAIN SIGNALS | SELECTION FROM MENU | ||
| FR LH SENSOR (km/h, mph) |
x | x | x | Wheel speed (km/h, mph) calculated by front LH wheel sensor signal is displayed. |
| FR RH SENSOR (km/h, mph) |
x | x | x | Wheel speed (km/h, mph) calculated by front RH wheel sensor signal is displayed. |
| RR LH SENSOR (km/h, mph) |
x | x | x | Wheel speed (km/h, mph) calculated by rear LH wheel sensor signal is displayed. |
| RR RH SENSOR (km/h, mph) |
x | x | x | Wheel speed (km/h, mph) calculated by rear RH wheel sensor signal is displayed. |
| DECEL G-SEN (G) |
x | x | x | Longitudinal acceleration (G) detected by decel G-sensor is displayed. |
| FR RH IN SOL (On/Off) |
- | x | x | Front RH IN ABS solenoid (On/Off) status is displayed. |
| FR RH OUT SOL (On/Off) |
- | x | x | Front RH OUT ABS solenoid (On/Off) status is displayed. |
| FR LH IN SOL (On/Off) |
- | x | x | Front LH IN ABS solenoid (On/Off) status is displayed. |
| FR LH OUT SOL (On/Off) |
- | x | x | Front LH OUT ABS solenoid (On/Off) status is displayed. |
| RR RH IN SOL (On/Off) |
- | x | x | Rear RH IN ABS solenoid (On/Off) status is displayed. |
| RR RH OUT SOL (On/Off) |
- | x | x | Rear RH OUT ABS solenoid (On/Off) status is displayed. |
| RR LH IN SOL (On/Off) |
- | x | x | Rear LH IN ABS solenoid (On/Off) status is displayed. |
| RR LH OUT SOL (On/Off) |
- | x | x | Rear LH OUT ABS solenoid (On/Off) status is displayed. |
| EBD WARN LAMP (On/Off) |
- | - | x | Brake warning lamp (On/Off) status is displayed. |
| STOP LAMP SW (On/Off) |
x | x | x | Stop lamp switch (On/Off) status is displayed. |
| MOTOR RELAY (On/Off) |
- | x | x | ABS motor relay signal (On/Off) status is displayed. |
| ACTUATOR RLY (On/Off) |
- | x | x | ABS actuator relay signal (On/Off) status is displayed. |
| ABS WARN LAMP (On/Off) |
- | x | x | ABS warning lamp (On/Off) status is displayed. |
| OFF LAMP (On/Off) |
- | x | x | VDC OFF Lamp (On/Off) status is displayed. |
| OFF SW (On/Off) |
x | x | x | VDC OFF switch (On/Off) status is displayed. |
| SLIP LAMP (On/Off) |
- | x | x | SLIP indicator lamp (On/Off) status is displayed. |
| BATTERY VOLT (V) |
x | x | x | Voltage (V) supplied to ABS actuator and electric unit (control unit) is displayed. |
| GEAR (1, 2, 3, 4, 5) |
x | x | x | Gear position (1, 2, 3, 4, 5) judged by transmission range switch signal is displayed. |
| SLCT LVR POSI (P, N, D) |
x | x | x | Shift position (P, N, D) judged by transmission range switch signal. |
| ENGINE SPEED (rpm) |
x | x | x | Engine speed (rpm) judged by CAN communication signal is displayed. |
| YAW RATE SEN (d/s) |
x | x | x | Yaw rate (d/s) detected by yaw rate sensor is displayed. |
| R POSI SIG (On/Off) |
- | - | x | Reverse shift position (On/Off) judged by transmission range switch signal. |
| N POSI SIG (On/Off) |
- | - | x | Shift position judged by transmission range switch signal. |
| P POSI SIG (On/Off) |
- | - | x | Shift position judged by transmission range switch signal. |
| CV1 (On/Off) |
- | - | x | Front side switch-over solenoid valve (cut valve) (On/Off) status is displayed. |
| CV2 (On/Off) |
- | - | x | Rear side switch-over solenoid valve (cut-valve) (On/Off) status is displayed. |
| SV1 (On/Off) |
- | - | x | Front side switch-over solenoid valve (suction valve) (On/Off) status is displayed. |
| SV2 (On/Off) |
- | - | x | Rear side switch-over solenoid valve (suction valve) (On/Off) status is displayed. |
| 2WD/4WD (2WD/4WD) |
- | - | x | It recognizes on software whether it is 2WD and whether it is in 4WD state. |
| ACCEL POS SIG (%) |
x | - | x | Throttle valve open/close status judged by CAN communication signal is displayed. |
| SIDE G-SENSOR (m/s2 ) |
x | - | x | Transverse acceleration detected by side G-sensor is displayed. |
| STR ANGLE SIG (deg) |
x | - | x | Steering angle detected by steering angle sensor is displayed. |
| BST OPER SIG (On/Off) |
- | - | x | Active booster operation (On/Off) status is displayed. |
| PRESS SENSOR (bar) |
x | - | x | Brake pressure detected by pressure sensor is displayed. |
| EBD SIGNAL (On/Off) |
- | - | x | EBD operation (On/Off) status is displayed. |
| ABS SIGNAL (On/Off) |
- | - | x | ABS operation (On/Off) status is displayed. |
| TCS SIGNAL (On/Off) |
- | - | x | TCS operation (On/Off) status is displayed. |
| VDC SIGNAL (On/Off) |
- | - | x | VDC operation (On/Off) status is displayed. |
| ABS FAIL SIG (On/Off) |
- | - | x | ABS fail signal (On/Off) status is displayed. |
| TCS FAIL SIG (On/Off) |
- | - | x | TCS fail signal (On/Off) status is displayed. |
| VDC FAIL SIG (On/Off) |
- | - | x | VDC fail signal (On/Off) status is displayed. |
| CRANKING SIG (On/Off) |
- | - | x | The input state of the key SW START position signal is displayed. |
| FLUID LEV SW (On/Off) |
x | - | x | Brake fluid level switch (On/Off) status is displayed. |
| PRESS SEN2 (bar) |
- | - | x | Brake pressure detected by pressure sensor is displayed. |
| DELTA S SEN (mm) |
- | - | x | The amount of stroke sensor movements in the active booster detected by DELTA S SEN is displayed. |
| RELEASE SW NO (On/Off) |
- | - | x | Release switch signal (On/Off) status is displayed. "On" indicates that the brake pedal is depressed. "Off" indicates that the brake pedal is released. |
| RELEASE SW NC (On/Off) |
- | - | x | Release switch signal (On/Off) status is displayed. "Off" indicates that the brake pedal is depressed. "On" indicates that the brake pedal is released. |
| OHB FAIL (On/Off) |
- | - | x | OHB fail status is displayed. |
| HBA FAIL (On/Off) |
- | - | x | HBA fail status is displayed. |
| OHB SIG (On/Off) |
- | - | x | OHB operation (On/Off) status is displayed. |
| HBA SIG (On/Off) |
- | - | x | HBA operation (On/Off) status is displayed. |
| STP OFF RLY (On/Off) |
- | - | x | Stop lamp relay signal (On/Off) status is displayed. |
| x: Applicable -: Not applicable |
||||