Diagnosis Procedure

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.

CHECK CONNECTOR
1. Turn ignition switch OFF.
2. Disconnect the ABS actuator and electric unit (control unit) connector.
3. Check the terminals for deformation, disconnection, looseness, and so on. If there is a malfunction, repair or replace the terminal.
4. Reconnect connector and perform self-diagnosis.
  Is "CAN COMM CIRCUIT" displayed in self-diagnosis display items?
  
  YES: Print out the self-diagnostic results, and refer to "TROUBLE DIAGNOSIS FLOW CHART ".
  
  NO: Connector terminal is loose, damaged, open, or shorted.