LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2004 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 899 (Brake Control System (VDC/TCS/Abs)) >> DTC/Circuit Diagnosis >> DTC C1164, C1165, C1166, C1167: CV/SV System >> Component Inspection

Component Inspection

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK ACTIVE TEST 
    1. Select each test menu item on "ACTIVE TEST".
    2. On the display, touch "Up", "ACT UP", and "ACT KEEP", and check that the system operates as shown in the table below.
      Operation ABS solenoid valve (ACT)
      Up ACT UP ACT KEEP
      FR RH ABS SOLENOID (ACT) FR RH IN SOL Off Off Off
      FR RH OUT SOL Off Off Off
      CV1 Off On On
      SV1 Off On(1) Off
      FR LH ABS SOLENOID (ACT) FR LH IN SOL Off Off Off
      FR LH OUT SOL Off Off Off
      CV1 Off On On
      SV1 Off On(1) Off
      RR RH ABS SOLENOID (ACT) RR RH IN SOL Off Off Off
      RR RH OUT SOL Off Off Off
      CV2 Off On On
      SV2 Off On(1) Off
      RR LH ABS SOLENOID (ACT) RR LH IN SOL Off Off Off
      RR LH OUT SOL Off Off Off
      CV2 Off On On
      SV2 Off On(1) Off
      (1) On for 1 to 2 seconds after the touch, and then Off

      Is the inspection result normal? 

      YES: Inspection End

      NO: Go to diagnosis procedure. Refer to "DIAGNOSIS PROCEDURE ".