Calibration Of DECEL G Sensor

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: To calibrate the decel G sensor, make sure to use CONSULT (Calibration cannot be done without CONSULT)

ALIGN THE VEHICLE STATUS
Stop vehicle with front wheels in straight-ahead position.

: GO TO 2
PERFORM CALIBRATION OF DECEL G SENSOR
1. On the CONSULT screen, touch "WORK SUPPORT" and "DECEL G-SEN CALIBRATION" in order.
2. Touch "START".
3. After approximately 10 seconds, touch "END".
  NOTE: After approximately 60 seconds, it ends automatically.
4. Turn ignition switch OFF, then turn it ON again.
  CAUTION: Be sure to perform above operation.
  
  : GO TO 3
CHECK DATA MONITOR
1. Run vehicle with front wheels in straight-ahead position, then stop.
2. Select "DATA MONITOR". Then make sure "DECEL G SEN" is within ±0.08G.
  Is the inspection result normal?
  
  YES: GO TO 4
  
  NO: Perform calibration of decel G sensor again, GO TO 1
ERASE THE SELF-DIAGNOSIS MEMORY
Erase the self-diagnosis memory of the ABS actuator and electric unit (control unit) and ECM.
- ABS actuator and electric unit (control unit): Refer to "CONSULT FUNCTION (ABS) ".
- ECM: Refer to "CONSULT FUNCTION ".
  Are the memories erased?
  
  YES: Inspection End
  
  NO: Check the items indicated by the self-diagnosis.