Calibration Procedure

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.

The compass display is equipped with an automatic correction function. If the compass display reads "CAL" or the direction is not shown correctly, perform the correction procedure below.

Press and hold the (N) switch for about 10 seconds (with HomeLink universal transceiver) or the mode switch for about 13 seconds (without HomeLink universal transceiver). The display will read "CAL".
Drive the vehicle slowly in a circle, in an open, safe place. The initial calibration is completed in about 3 turns.

NOTE: In places where the terrestrial magnetism is extremely disturbed, the initial correction may start automatically.

Fig 1: Identifying Compass Display (With And Without Homelink Universal Transceiver)

Courtesy of NISSAN NORTH AMERICA, INC.