Diagnosis Procedure

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.

Regarding Wiring Diagram information, refer to "WIRING DIAGRAM ".

CHECK WASHER FLUID LEVEL SWITCH SIGNAL CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect combination meter connector and washer fluid level switch connector.
3. Check continuity between combination meter harness connector M24 (A) terminal 37 and washer fluid level switch harness connector E106 (B) terminal 1.
  37 - 1: Continuity should exist.
4. Check continuity between combination meter harness connector M24 (A) terminal 37 and ground.
  37 - Ground: Continuity should not exist.
  
  Fig 1: Checking Continuity Between Combination Meter Connector M24 Terminal 37 And Washer Fluid Level Switch Connector E106 Terminal 1
  Courtesy of NISSAN NORTH AMERICA, INC.
  
  Is the inspection result normal?
  
  YES: GO TO 2
  
  NO: Repair harness or connector.
CHECK WASHER FLUID LEVEL SWITCH GROUND CIRCUIT
Check continuity between washer fluid level switch harness connector E106 terminal 2 and ground.

2 - Ground: Continuity should exist.

Fig 2: Checking Continuity Between Washer Fluid Level Switch Connector E106 Terminal 2 And Ground
Courtesy of NISSAN NORTH AMERICA, INC.

Is the inspection result normal?

YES: Inspection End.

NO: Repair harness or connector.