Diagnosis Procedure
WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK HARNESS CONTINUITY (OPEN CIRCUIT)
- Turn the ignition switch OFF.
- Disconnect the battery cable from the negative terminal.
- Disconnect the following harness connectors.
- ECM
- Transfer control unit
- ABS actuator and electric unit (control unit)
- Check the continuity between the transfer control unit harness connector and the ABS actuator and electric unit (control unit) harness connector.
Transfer control unit harness connector ABS actuator and electric unit (control unit) harness connector Continuity Connector No. Terminal No. Connector No. Terminal No. E142 7 E125 11 Existed 8 15 Existed Is the inspection result normal?
YES (Present error): Check the following items again.
- Decision of CAN system type.
- Not received CONSULT data (SELF-DIAG RESULTS, CAN DIAG SUPPORT MNTR).
- Procedure for detecting root cause.
YES (Past error): Error was detected in the main line between the transfer control unit and the ABS actuator and electric unit (control unit).
NO: Repair the main line between the transfer control unit and the ABS actuator and electric unit (control unit).