Accelerator Pedal Position Sensor

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.

Reconnect all harness connectors disconnected.
Turn ignition switch ON.

Check voltage between ECM terminals 106 (APP sensor 1 signal), 98 (APP sensor 2 signal) and ground under the following conditions.

Terminal	Accelerator pedal	Voltage
106 (Accelerator pedal position sensor 1)	Fully released	0.5 - 1.0 V
106 (Accelerator pedal position sensor 1)	Fully depressed	4.2 - 4.8 V
98 (Accelerator pedal position sensor 2)	Fully released	0.25 - 0.5 V
98 (Accelerator pedal position sensor 2)	Fully depressed	2.0 - 2.5 V

If NG, replace accelerator pedal assembly, refer to UNIT REMOVAL AND INSTALLATION , and go to next step.
Perform "ACCELERATOR PEDAL RELEASED POSITION LEARNING ".
Perform "THROTTLE VALVE CLOSED POSITION LEARNING ".
Perform "IDLE AIR VOLUME LEARNING ".

Fig 1: Checking Voltage Between ECM Terminals 106, 98 And Ground
Courtesy of NISSAN NORTH AMERICA, INC.