Accelerator Pedal Position Sensor
WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
- Reconnect all harness connectors disconnected.
- Turn ignition switch ON.
- Check voltage between ECM terminals 106 (APP sensor 1 signal), 98 (APP sensor 2 signal) and ground under the following conditions.
Terminal Accelerator pedal Voltage 106
(Accelerator pedal position sensor 1)Fully released 0.5 - 1.0 V Fully depressed 4.2 - 4.8 V 98
(Accelerator pedal position sensor 2)Fully released 0.25 - 0.5 V Fully depressed 2.0 - 2.5 V - If NG, replace accelerator pedal assembly, refer to UNIT REMOVAL AND INSTALLATION , and go to next step.
- Perform "ACCELERATOR PEDAL RELEASED POSITION LEARNING ".
- Perform "THROTTLE VALVE CLOSED POSITION LEARNING ".
- Perform "IDLE AIR VOLUME LEARNING ".