LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2004 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 891 (Engine Control System (Diagnostic Codes & Symptom Tests)) >> DTC/Circuit Diagnosis >> DTC P2119: Electric Throttle Control Actuator >> On Board Diagnosis Logic >> Fail-Safe Mode

Fail-Safe Mode

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.

When the malfunction is detected, ECM enters fail-safe mode and the MIL lights up.

Detected items Engine operating condition in fail-safe mode
Malfunction A The ECM controls the electric throttle actuator by regulating the throttle opening around the idle position. The engine speed will not rise more than 2, 000 RPM.
Malfunction B ECM controls the electric throttle control actuator by regulating the throttle opening to 20 degrees or less.
Malfunction C While the vehicle is driving, it slows down gradually by fuel cut. After the vehicle stops, the engine stalls. The engine can restart in N or P position, and engine speed will not exceed 1, 000 RPM or more.