LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2004 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 891 (Engine Control System (Diagnostic Codes & Symptom Tests)) >> DTC/Circuit Diagnosis >> DTC P1572: ASCD Brake Switch >> DTC Confirmation Procedure >> With Consult

With Consult

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
  1. Start engine (VDC switch OFF).
  2. Select "DATA MONITOR" mode with CONSULT.
  3. Press MAIN switch and make sure that CRUISE indicator lights up.
  4. Drive the vehicle for at least 5 consecutive seconds under the following condition.
    VHCL SPEED SE More than 30 km/h (19 MPH)
    Selector lever Suitable position
  5. Check 1st trip DTC.
  6. If 1st trip DTC is detected, go to "DIAGNOSIS PROCEDURE ".

    If 1st trip DTC is not detected, go to the following step.

  7. Drive the vehicle for at least 5 consecutive seconds under the following condition.
    VHCL SPEED SE More than 30 km/h (19 MPH)
    Selector lever Suitable position
    Driving location Depress the brake pedal for more than five seconds so as not to come off from the above-mentioned condition.
  8. Check 1st trip DTC.
  9. If 1st trip DTC is detected, go to "DIAGNOSIS PROCEDURE ".
scientia non olet · About LEMON Manuals