LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2004 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 891 (Engine Control System (Diagnostic Codes & Symptom Tests)) >> DTC/Circuit Diagnosis >> DTC P1220: Fuel Pump Control Module (FPCM) >> DTC Confirmation Procedure >> With Consult

With Consult

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition switch ON and select "DATA MONITOR" mode with CONSULT.
  2. Make sure that "COOLAN TEMP/S" indicates less than 70°C (158°F). If not, cool down the engine.
  3. Start engine.
  4. Hold vehicle at the following conditions for 12 seconds.
    ENG SPEED 900 - 2, 600 RPM
    VHCL SPEED SE More than 70 km/h (43 MPH)
    B/FUEL SCHDL 0 - 25 msec
    Selector lever Suitable position
  5. Check 1st trip DTC.
  6. If 1st trip DTC is detected, go to "DIAGNOSIS PROCEDURE ".