LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2004 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 891 (Engine Control System (Diagnostic Codes & Symptom Tests)) >> DTC/Circuit Diagnosis >> DTC P1140, P1145: IVT Control Position Sensor >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
  1. If DTC Confirmation Procedure has been previously conducted, always perform the following before conducting the next step.
    1. Turn ignition switch OFF and wait at least 10 seconds.
    2. Turn ignition switch ON.
    3. Turn ignition switch OFF and wait at least 10 seconds.
  2. Turn ignition switch ON.
  3. Maintain the following conditions for at least 10 seconds.
    ENG SPEED More than idle speed
    Selector lever P or N position
  4. Check 1st trip DTC.
  5. If 1st trip DTC is detected, go to "DIAGNOSIS PROCEDURE ".
scientia non olet · About LEMON Manuals