With Consult

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.

Turn ignition switch ON.

Select "P/N POSI SW" in "DATA MONITOR" mode with CONSULT. Then check the "P/N POSI SW" signal under the following conditions.

Position (Selector lever)	Known-good signal
N or P position	ON
Except the above position	OFF

If NG, go to "DIAGNOSIS PROCEDURE ".

If OK, go to following step.

Select "DATA MONITOR" mode with CONSULT.
Start engine and warm it up to normal operating temperature.

Maintain the following conditions for at least 60 consecutive seconds.

ENG SPEED	1, 000 - 6, 375 RPM
COOLAN TEMP/S	More than 70°C (158°F)
B/FUEL SCHDL	2.0 - 31.8 msec
VHCL SPEED SE	More than 64 km/h (40 MPH)
Selector lever	Suitable position

Check 1st trip DTC.
If 1st trip DTC is detected, go to "DIAGNOSIS PROCEDURE ".