DTC Confirmation Procedure: Notes

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.

PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.
1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. Turn ignition switch OFF and wait at least 10 seconds.
  TESTING CONDITION:
  
  Before performing the following procedure, confirm that battery voltage is 11 V or more at idle .
  
  : GO TO 2.
PERFORM DTC CONFIRMATION PROCEDURE-I
WITH CONSULT
1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. Select "DATA MONITOR" mode with CONSULT.
4. Check the indication of "COOLAN TEMP/S".
  WITH GST
  
  Follow the procedure "With CONSULT" above.
  
  Is the value of "COOLAN TEMP/S" between 5°C (41°F) and 36°C (97°F)?
  
  YES: GO TO 3.
  
  NO-1 [If it is below 5°C (41°F)]: Warm up the engine until the value of "COOLAN TEMP/S" reaches 5°C (41°F) or more. Retry from step 1.
  
  NO-2 [If it is above 36°C (97°F)]: Cool engine down to less than 36°C (97°F). Retry from step 1.
PERFORM DTC CONFIRMATION PROCEDURE-II