Without CONSULT

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.

Remove EVAP canister vent control valve from EVAP canister. Refer to EVAP CANISTER .
Check portion B of EVAP canister vent control valve for being rusted.

Fig 1: Identifying Rusted Portion Of EVAP Canister Vent Control Valve
Courtesy of NISSAN NORTH AMERICA, INC.

Check air passage continuity and operation delay time under the following conditions.

Make sure that new O-ring is installed properly.

Condition	Air passage continuity between A and B
12 V direct current supply between terminals 1 and 2	No
OFF	Yes

Fig 2: Cleaning Air Passage Of EVAP Canister Vent Control Valve Using Air Blower

Courtesy of NISSAN NORTH AMERICA, INC.

Operation takes less than 1 second.

If NG, replace EVAP canister vent control valve. Refer to EVAP CANISTER .

If OK, go to next step.

Clean the air passage (Portion A to B ) of EVAP canister vent control valve using an air blower.
Perform step 3 again.