With CONSULT

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.

Remove EVAP canister vent control valve from EVAP canister. Refer to EVAP CANISTER .
Check portion B of EVAP canister vent control valve for being rusted.
If NG, replace EVAP canister vent control valve. Refer to EVAP CANISTER .

If OK, go to next step.
Reconnect harness connectors disconnected.
Turn ignition switch ON.
Perform "VENT CONTROL/V" in "ACTIVE TEST" mode.

Check air passage continuity and operation delay time.

Make sure that new O-ring is installed properly.

Condition VENT CONTROL/V	Air passage continuity between A and B
ON	No
OFF	Yes

Fig 1: Identifying Rusted Portion Of EVAP Canister Vent Control Valve

Courtesy of NISSAN NORTH AMERICA, INC.

Operation takes less than 1 second.

If NG, replace EVAP canister vent control valve. Refer to EVAP CANISTER .

If OK, go to next step.

Clean the air passage (Portion A to B ) of EVAP canister vent control valve using an air blower.
Perform step 6 again.