LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2004 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 891 (Engine Control System (Diagnostic Codes & Symptom Tests)) >> DTC/Circuit Diagnosis >> DTC P0443: EVAP Canister Purge Volume Control Solenoid Valve >> DTC Confirmation Procedure >> Procedure For Malfunction A >> With GST

With GST

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition switch ON.
  2. Set voltmeter probes to ECM terminal 107 (FTT sensor signal) and ground.
  3. Check that the voltage is 3.1 - 4.2 V.
  4. Start engine and wait at least 60 seconds.
  5. Check 1st trip DTC.
  6. If 1st trip DTC is detected, go to "DIAGNOSIS PROCEDURE ".
    Fig 1: Checking Voltage Between ECM Terminal 107 And Ground
    G08690615Courtesy of NISSAN NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals