LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2004 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 891 (Engine Control System (Diagnostic Codes & Symptom Tests)) >> DTC/Circuit Diagnosis >> DTC P0340: CMP Sensor (Phase) >> On Board Diagnosis Logic

On Board Diagnosis Logic

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
DTC No. Trouble diagnosis name DTC detecting condition Possible cause
P0340
0340
Camshaft position sensor (PHASE) circuit
  • The cylinder No. signal is not sent to ECM for the first few seconds during engine cranking.
  • The cylinder No. signal is not sent to ECM during engine running.
  • The cylinder No. signal is not in the normal pattern during engine running.
  • Harness or connectors (The sensor circuit is open or shorted)
  • Camshaft position sensor (PHASE)
  • Camshaft (Exhaust)
  • Starter motor (Refer to "SYSTEM DIAGRAM ".)
  • Starting system circuit (Refer to "SYSTEM DIAGRAM ".)
  • Dead (Weak) battery