Component Function Check
WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK FUEL TANK TEMPERATURE (FTT) SENSOR
- Turn ignition switch OFF.
- Disconnect fuel level sensor unit and fuel pump harness connector.
- Remove fuel level sensor unit. Refer to "REMOVAL AND INSTALLATION ".
- Check resistance between fuel level sensor unit and fuel pump terminals by heating with hot water as shown in the figure below.
Terminals Condition Resistance (kΩ) 4 and 3 Temperature [°C (°F)] 20 (68) 2.3 - 2.7 50 (122) 0.79 - 0.90 Courtesy of NISSAN NORTH AMERICA, INC.
Is the inspection result normal?
YES: GO TO 2.
NO: Proceed to "DIAGNOSIS PROCEDURE ".
- CHECK INTERMITTENT INCIDENT
Check intermittent incident. Refer to "INTERMITTENT INCIDENT ".
Is the inspection result normal?
YES: INSPECTION END
NO: Proceed to "DIAGNOSIS PROCEDURE ".