LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2004 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 891 (Engine Control System (Diagnostic Codes & Symptom Tests)) >> DTC/Circuit Diagnosis >> DTC P0130, P0150: A/F Sensor 1 >> DTC Confirmation Procedure >> Procedure For Malfunction B >> With CONSULT

With CONSULT

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
  1. Start engine and warm it up to normal operating temperature.
  2. Select "A/F SEN1 (B1)" or "A/F SEN1 (B2)" in "DATA MONITOR" mode with CONSULT.
  3. Check "A/F SEN1 (B1)" or "A/F SEN1 (B2)" indication.

    If the indication is constantly approx. 2.2 V and does not fluctuates, go to "DIAGNOSIS PROCEDURE ".

    If the indication fluctuates around 2.2 V, go to next step.

  4. Select "A/F SEN1 (B1) P1276" (for DTC P0130) or "A/F SEN1 (B2) P1286" (for DTC P0150) of "A/F SEN1" in "DTC WORK SUPPORT" mode with CONSULT.
  5. Touch "START".
  6. When the following conditions are met, "TESTING" will be displayed on the CONSULT screen.
    ENG SPEED 850 - 3, 200 RPM
    VHCL SPEED SE More than 64 km/h (40 MPH)
    B/FUEL SCHDL 1.0 - 8.0 msec
    Shift lever D position

    If "TESTING" is not displayed after 20 seconds, retry from step  2.

  7. Release accelerator pedal fully.
    NOTE: Never apply brake during releasing the accelerator pedal.
  8. Make sure that "TESTING" changes to "COMPLETED".

    If "TESTING" changed to "OUT OF CONDITION", retry from step  6.

  9. Make sure that "OK" is displayed after touching "SELF-DIAG RESULT".

    If "NG" is displayed, go to "DIAGNOSIS PROCEDURE ".

scientia non olet · About LEMON Manuals