LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2004 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 891 (Engine Control System (Diagnostic Codes & Symptom Tests)) >> DTC/Circuit Diagnosis >> DTC P0127: IAT Sensor >> DTC Confirmation Procedure >> With Consult

With Consult

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
  1. Wait until engine coolant temperature is less than 90°C (194°F)
    1. Turn ignition switch ON.
    2. Select "DATA MONITOR" mode with CONSULT.
    3. Check the engine coolant temperature.
    4. If the engine coolant temperature is not less than 90°C (194°F), turn ignition switch OFF and cool down engine.
      • Perform the following steps before engine coolant temperature is above 90°C (194°F).
  2. Turn ignition switch ON.
  3. Select "DATA MONITOR" mode with CONSULT.
  4. Start engine.
  5. Hold vehicle speed at more than 70 km/h (43 MPH) for 100 consecutive seconds.
  6. Check 1st trip DTC.
  7. If 1st trip DTC is detected, go to "DIAGNOSIS PROCEDURE ".
scientia non olet · About LEMON Manuals