Hood Stay Disposal

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.

Fix hood stay (1) using a vise (C).
Using hacksaw (A) slowly make 2 holes in the hood stay, in numerical order as shown in the figure below.
CAUTION:
- When cutting a hole on hood stay, always cover a hacksaw using a shop cloth (B) to avoid scattering metal fragments or oil.
- Wear eye protection (safety glasses).
- Wear gloves.
Fig 1: Making Holes In Hoodstay Using Hacksaw
Courtesy of NISSAN NORTH AMERICA, INC.

A: 20 mm (0.8 in)

B: Cut at the groove.

Fig 2: Identifying Groove Cut Dimension
Courtesy of NISSAN NORTH AMERICA, INC.